Step 1: Turn on the Glass Dome Vaporizer

Plug in the vape, by either plugging it in or hitting the on switch, and remove the glass dome top. Let it heat up for about 3 minutes. It will usually take longer than 3 minutes though so just pay attention.

Step 2: Pack the Glass Dome Vaporizer

Once warmed up place your herb on the metal heating plate. Spread it out evenly over the plate but try not to burn yourself, so user friendly! But honestly be careful not to burn yourself because it is pretty easy with these ancient vaporizers.

Step 3: Heat up the Glass Dome Vaporizer

Now put the glass dome back on top of the vape. Wait about another 3 to 5 minutes for the vapor to materialize, could take longer in some instances. Most likely it will take longer so prepare yourself for that ahead of time.

Step 4: Begin use of the Glass Dome Vaporizer

When you see vapor form in the dome and start to swirl around you can take a hit and clear the glass dome. Generally it will give you one full hit when you fill it up so wait for it to fill all the way.

Step 5: Refill the Glass Dome Vaporizer

Repeat until you’re done and either replace herb or throw the entire unit away and buy a better vaporizer. Completely up to you. But judging from my experience with this vaporizer you might want to just throw it out instead of refilling it.

Tip: A Glass Dome Vaporizer is generally not made of the highest quality. So be extra careful when operating or handling it.

If you haven’t read the review of the Glass Dome Vaporizer you probably should. You can find the Glass Dome Vaporizer review here. Before you order the Glassdome Vaporizer compare prices and vendors.

60
Ease Of Use
35
Design/Build
75
Performance
20
Efficiency
80
Vapor Quality
Users (1 vote) 54
What people say... 1 Leave your rating
Functional- Patience Required
Definitely not a piece for the impatient. Takes a few minutes to heat up, each hit takes a couple minutes to build up, and it has to be turned off (or for some, unplugged) every 15 minutes so it doesn't overheat or burn. The hits are really quality if you can figure out how much smoke in the bubble adds up to a hit. A bit clunky for sure, but it's really straight forward; pop the bubble off, load it, pop it back on, turn it on and wait, then hit. It's user friendly, cheap, and functional.
August 18, 2017, 5:08 am
Ease Of Use60
Design/Build35
Performance75
Efficiency20
Vapor Quality80
0
0
Leave your rating


Related posts:

A Review Of The ThermoVape T1 Vaporizer