5 Easy Steps on How to Use the AroMed 4.0 Vaporizer

By Vaporizer Sale on July 21, 2010 in Articles, How to Use

Step 1: Fill the AroMed water pipe

First wash out the water filter, to get rid of any dust or anything else that might have got in there when it was being packed to ship. Next fill the water filter with about a thumb size of water. Make sure you don’t put too much in because it can result in less vapor.

Step 2: Attach the AroMed whip

Now connect the silicon tube to the mouthpiece of the water filter and then secure the water filter with the rubber band they include in the package. Securing the water filter is definitely important so don’t forget to do so.

Step 3: Pack the AroMed

Next take your finely ground herb and pinch some into the herb holder. Of course make sure you don’t put too much in because you don’t want to waste any of the herb.

Step 4: Heat up the AroMed

Next put the heating element into the open end of the herb chamber you’ll hear them click together. Now plug it in and press the red button and select your desired heating temperature. Use the plus and minus buttons to set it to your desired temperature, between 375 and 420 degrees is recommended.

Step 5: Begin use of the AroMed

When the blinking red light goes off in the upper left hand corner of the vape that means it has reached the temperature and is ready to go. Start pulling from the whip gently and slowly at first until you get the desired size hit of vapor you want.

Tip: When using the AroMed be careful handling the water pipe when the whip is attached, it makes it pretty easy to knock over.

If you haven’t read the review of the AroMed 4.0 what’s the hold up? You can find it here. Thinking about buying this vaporizer? Compare prices and vendors for the AroMed first!