Step 1: Turn on the Easy Vape
Adjust the temperature knob on the Easy Vape to around 350 degrees, as this is the recommended setting. While smoking you can change it around to find what temperature best suits you though. The vape only takes about 5 minutes to heat up which isn’t too long but definitely isn’t the fastest around.
Step 2: Pack the Easy Vape
Grind up your herb extra fine for this vape because it can waste some herb that isn’t grounded up very small. Place the herb in the bowl piece and don’t fill it up more than a 3rd of the way.
Step 3: Attach the whip to the Easy Vape
Place the bowl end of the whip onto the ceramic heating element. Like I said before it should fit perfectly on there and feel set. This will start the vaporization process of course.
Step 4: Begin use of the Easy Vape
Gently pull for about 10 seconds giving the vapor a chance to build up. After that start pulling harder and you should get a decent amount of vapor. Also adjust the temperature while smoking if you find the vapor to be too harsh or not good tasting.
Step 5: Refill the Easy Vape
When you’re done simply remove the whip from the ceramic heating element and discard the left over herb. Then replace it with more herb, finely ground up, and repeat the previous steps until you’re done the session.
Tip: When using the Easy Vape make sure the whip attachment is firmly secure. I found that if you don’t make sure it is really on there it can sometimes slip off and spill your herb. Definitely something you want to avoid.
Be the first to leave a rating.