Step 1: Pack the Pocket Vape

First grind up your herb and then place it into the filling cap but make sure not to pack down the herb or fill it completely.

Step 2: Fill the Pocket Vape butane cartridge

Now screw the whip onto the filling cap. If you haven’t done so already, fill the butane cartridge and be very careful not to overfill it.

Step 3: Insert the Pocket Vape butane cartridge

Put the butane cartridge into the Pocket Vape, connecting the top of the cartridge to the gas line that you will see near the top.

Step 4: Attach the Pocket Vape whip

Next put the filling cap with the whip attached into the hole in the top of the vaporizer and pull the lid to open up the pocket vapor.

Step 5: Begin use of the Pocket Vape

Lastly pull the trigger on the Pocket Vape and let it heat up for about 30 seconds. Now you can inhale and clear the vapor. Always wait about 30 seconds after pulling the trigger before pulling. When done clear out the herb from the filling cap and repeat the previous steps until you’re done with your session.

If you haven’t read the review of the VP-600 I think you are procrastinating a bit too much. You can find it here. Ready to see the best places you can buy this vaporizer? Compare prices and vendors for the Pocket Vape.

0
Ease Of Use
0
Design/Build
0
Performance
0
Efficiency
0
Vapor Quality
Users (0 votes) 0
What people say... 0 Leave your rating

Be the first to leave a rating.

Leave your rating


Related posts:

A Review Of The ThermoVape T1 Vaporizer