Step 1: Turn on the Predator

Turn on the Predator and give it about 10 minutes to heat up, like I said the stainless steel heating element will take a little longer than most vapes. Not much longer, but you are probably looking at around 10 minutes for your heat up time, on average.

Step 2: Pack the Predator

Once the Predator is heated up grind up your herb and prepare to place it in the bowl piece. Of course only place a small amount in so that you are leaving a good surface area for the vapor to pass through. But I found that burning your herb with this vaporizer wasn’t very easy to do, so don’t worry too much.

Step 3: Attach the Predator whip

Now slide the bowl piece’s nozzle onto the heating element until it stops. When it does stop you’re going to hear a clicking noise, that is the lock in whip locking itself into place.

Step 4: Begin use of the Predator

This will begin the vapoization process. Take the mouthpiece end of the whip and place it to your mouth and begin to inhale. Experiment with different temperatures to see what is working best for you.

Step 5: Refill the Predator

When you’re done you can unlock the whip from the vape by pressing the back of the nozzle, but be careful because it heats up enough where it will burn you. So either use gloves or give it a little time to cool down if you’re done with the session. After that replace your herb and repeat the previous steps until done.

Tip: When attaching the whip make sure you hear it click and lock into place. You don’t want it to fall off and spill your herb while vaporizing.

If you haven’t read the review of the Predator Arnold and Governor Jesse “The Body” Ventura advise you that you should. You can find it here. Want to get this vaporizer? Be smart and compare prices and vendors for the Predator before you decide!

Ease Of Use
Vapor Quality
Users (0 votes) 0
What people say... 0 Leave your rating

Be the first to leave a rating.

Leave your rating

Related posts:

A Review Of The ThermoVape T1 Vaporizer