Step 1: Pack the Vapor Genie
Ground up herb as finely as possible and place it in the top bowl piece. Next screw the lid on top that is supplied with the Vapor Genie.
Step 2: Light the Vapor Genie
Next you will light the lighter and place it in the center of the lip of the bowl and heat while pulling slowly for about 10 seconds. Make sure not to leave the lighter lit too long because you do not want to burn the herb.
Step 3: Begin use of the Vapor Genie
While slowly inhaling, like with any vape, it is not going to feel like there is smoke pouring in so make sure you don’t keep pulling just because of that reason.
Step 4: Stir the Vapor Genie
In between hits it is best to shake up the herb so that you renew the surface area and get a longer session out of one pack. This holds true with most vapes as well.
Step 5: Refill the Vapor Genie
When done you remove the lid on the Vapor Genie and empty out the leftover herb just like it were a bowl. Now you are ready to go again.
Tip: Be very meticulous about stirring the Vapor Genie between hits. It is going to greatly extend the life of the herb you packed in.
Be the first to leave a rating.