Step 1: Turn on the VaporSnake

First plug the adapter into the VaporSnake and then plug it into the wall. Turn on the vape and turn the temperature knob to the maximum setting and let it warm up completely for about 5 minutes

Step 2: Remove the VaporSnake herb chamber

Once it is at the desired temperature you can remove the herb chamber from the the vape, which like I said is right under the snake at the top.

Step 3: Pack the VaporSnake

Load the herb chamber with your ground up herb and of course be careful not to put too much in and end up wasting some herb.

Step 4: Begin use of the VaporSnake

Now place the herb chamber back in the vape. This will start to build the vapor up inside. Take a long steady pull the first time to get it to build up even more and being to smoke.

Step 5: Refill the VaporSnake

When finished remove the herb chamber from the Vapor Snake and discard of the vaporized herb. Simply repeat the previous steps to continue your session.

Tip: Using this vape is pretty easy and the fact that it is hand made does change the typical whip vaporizing experience so keep that in mind the first time you use it.

If you haven’t read the review for the VaporSnake then head on over to ride the snaaaaake! You can find it here. Thinking about buying this vaporizer? Compare prices and vendors for the VaporSnake first!

0
Ease Of Use
0
Design/Build
0
Performance
0
Efficiency
0
Vapor Quality
Users (0 votes) 0
What people say... 0 Leave your rating

Be the first to leave a rating.

Leave your rating


Related posts:

A Review Of The ThermoVape T1 Vaporizer