Step 1: Turn on the Vaporwarez
Adjust the temperature knob to full for about 10 minutes on first use, then set back to a little over half way as this is the recommended setting. While smoking you can change it around to find what temperature best suits you though. The vape only takes about 3 minutes to heat up like I said.
Step 2: Pack the Vaporwarez
Grind up your herb like usual. Place the herb in the bowl piece of the Vaporwarez and don’t fill it up more than a 3rd of the way. Obviously, filling it too much will result in burning your herb and will be a waste of it.
Step 3: Attach the Vaporwarez whip
Place the bowl end of the whip onto the ceramic heating element. Like I said before it should fit perfectly on there and not fall off at all. This will start the vaporization process. Also make sure the end of the whip is securely attached to the end of the heating element.
Step 4: Begin use of the Vaporwarez
Gently pull for about 10 seconds giving the vapor a chance to build up. After that start pulling harder and you should get a decent amount of vapor. Also adjust the temperature while smoking if you find the vapor to be too harsh or not good tasting. Remember taking faster hits you will get cooler vapor.
Step 5: Refill the Vaporwarez
When you’re done simply remove the whip from the ceramic heating element and discard the left over herb. Then replace it with more herb and repeat the previous steps until you’re done the session.
If you haven’t read the review of the Vaporwarez then I must say I am kind of angry. You won’t like me when I’m angry. You can find it here. Considering purchasing this vaporizer? Compare prices and vendors for the Vaporwarez before you buy!
Be the first to leave a rating.